step-by-step make it!


Homes+ (Australia) - - READERS’ HOMES -

You will need Bas­ket; mask­ing tape; mea­sur­ing tape; pen­cil; drill and drill bit (larger than elec­tric cord); pen­dant elec­tric light cord; bulb

STEP ONE Turn bas­ket up­side down. In the mid­dle of the out­side of the base, stick a piece of mask­ing tape. Mea­sure the cen­tre point of the base and mark the tape.

STEP TWO Drill a hole on pen­cil mark through base of bas­ket. Turn elec­tric­ity off. You could get an elec­tri­cian to do this con­nec­tion stage: feed the cord up through the bas­ket and con­nect bat­ten then bulb.

Newspapers in English

Newspapers from Australia

© PressReader. All rights reserved.