THIS IS THE ONLY PLACE we wish Phanteks had given us an extra inch (although there is the Shift X…). Modular SFX power supplies in this build are a nightmare. Install the cables first, and you can’t fit the PSU in place; install them afterward, and there’s not enough room to even push them in. On top of that, the rubber grommet bracket, with the magnetic folding Phanteks cover, is annoyingly pop-riveted into place. If you could remove that, or temporarily move it upward, it would make PSU installation so much easier. To get around this, we ended up pre-installing the cables into the PSU before securing it, then pushing the cables down as much as possible, in an attempt to flatten them. We then removed one of the rubber grommets from the cable pass-through to give us enough wiggle room to slide the PSU in and secure it in place.