Shop­ping list

Ba­sic card kit, plus

Papercraft Inspirations - - OCCASIONS -

* Paper­ma­nia Cap­sule El­e­ments 6x6in papers – Pig­ment, from Hob­by­craft

* Wild Rose Stu­dio clear stamp – Bella, from Handy Hippo

* Lawn Fawn dies – Party Bal­loons & Slide on * Over Lil’ Inker dies – * Of The Heart Al­te­new stamp set – Birth­day Greet­ings, from Seven Hills Crafts

* Black, green, pink, * & yel­low card Clear * ac­etate White em­boss­ing pow­der * Blue & grey al­co­hol * * mark­ers Black pen * Two coins Ad­he­sive * gems Die-cut­ting * ma­chine Heat gun

1 Cut a 12x9cm piece of white card. Colour the bot­tom half with blue al­co­hol mark­ers, fad­ing out to white at the top. Doo­dle a bor­der in black. Stamp and heat em­boss clouds and a sen­ti­ment then ad­here onto the left side of the panel, as shown. Add three ad­he­sive gems.

2 Die cut a straight, ver­ti­cal slider (from the Slide on Over set) on the right-hand side of the card, just above the cen­tre. Cut a 1.5cm semi-cir­cle in the top edge, 1cm in from the right-hand edge.

3 Stamp the ele­phant onto white card, then snip off the bal­loons. Colour the ele­phant, cut out and stick onto a 11x2cm strip of ac­etate. Die cut three bal­loons and at­tach onto the stamped image.

4 Die cut an ar­row in black card and stick onto a strip of white card. As­sem­ble the slider, at­tach­ing coins be­hind the bal­loons and ele­phant head with sticky foam pads that fit through the slider die cut. Stick the top coin to the ar­row card strip.

5 Layer a 12.5x9.5cm piece of black card onto a white A6 card base. To fin­ish, use sticky foam pads to at­tach the slider panel onto the card base.

Newspapers in English

Newspapers from Australia

© PressReader. All rights reserved.