Cool it with a Jet­stream and in­crease tool life

DEMM Engineering & Manufacturing - - PRODUCT WATCH -

Ideal for turn­ing ap­pli­ca­tions that in­volve ti­ta­nium, su­per­al­loys and other chal­leng­ing ma­te­ri­als, Seco’s Jet­stream Tool­ing Duo tech­nol­ogy ap­plies one or more additional coolant jets from a sec­ond di­rec­tion.

This re­moves heat from the cut­ting zone, al­low­ing higher cut­ting speeds, longer tool life, im­proved chip con­trol and in­creased pro­duc­tiv­ity.

The tech­nol­ogy di­rects the up­per coolant jet to the op­ti­mal point of the rake face, while the additional jet f lushes the clear­ance sur­face.

As a re­sult, the cut­ting edge re­ceives high-pres­sure coolant from two op­po­site di­rec­tions – above and be­low – max­imis­ing con­trol of the chip f low as well as cool­ing the cut­ting zone.

By adding the sec­ond coolant jet to its Jet­stream Tool­ing prod­uct, Seco has made it pos­si­ble to in­crease tool life by 10 per­cent as well as achieve bet­ter fin­ishes.

Jet­stream Tool­ing Duo in­cludes an op­tional in­ducer to im­prove per­for­mance in rough­ing con­di­tions where additional power is re­quired on the chip side and in ap­pli­ca­tions where chips tend to hit the in­ducer.

demm.co.nz/reader-en­quiry #D131208c

Newspapers in English

Newspapers from New Zealand

© PressReader. All rights reserved.