Turbo 10 PCD milling in­serts for smooth fin­ish­ing

DEMM Engineering & Manufacturing - - PROD­UCT WATCH -

PCD-tipped milling in­sert grades for use with its pop­u­lar Turbo 10 cut­ters. PCD05 and PCD20 are well-proven PCD grades that pro­duce un­matched sur­face qual­ity in fin­ish ma­chin­ing ap­pli­ca­tions, pri­mar­ily in alu­minium, but also in ti­ta­nium al­loys. These work­piece ma­te­ri­als are typ­i­cally found in aero­space and au­to­mo­tive ap­pli­ca­tions. The new grades are also highly ef­fec­tive in cut­ting poly­mers and fi­bre-re­in­forced com­pos­ites.

PCD05 and PCD20 milling in­sert grades work alone or along­side car­bide in­serts in the same Turbo 10 cut­ter body. When used with car­bide in­serts, the PCD in­sert grades serve as wiper in­serts in fixed pock­ets. Con­versely, run­ning the PCD05 and PCD20 in one Turbo 10 cut­ter body op­ti­mises their po­ten­tial and en­sures max­i­mum cut­ting pa­ram­e­ters.

Fea­tur­ing solid car­bide in­sert bod­ies, the PCD05 and PCD20 come in the com­pany´s X010 in­sert size with a cor­ner ra­dius of 0.4 mm (.016”) and wiper length of 1.08 mm ( 0.43”).

The Turbo 10 cut­ter bod­ies that hold the PCD05 and PCD20 in­clude pre­ci­sion milled pocket seats that im­prove run-out, sta­bil­ity and tool life by pro­vid­ing op­ti­mal con­tact be­tween the tool body and in­sert. In­te­grated through-coolant chan­nels sup­port high pro­duc­tiv­ity and pro­mote ex­cel­lent chip evac­u­a­tion. Be­cause of their high lev­els of f lex­i­bil­ity, Turbo 10 cut­ters work in slot­ting, shoul­der­ing, ramp­ing, fac­ing, pock­et­ing, plung­ing and turn milling ap­pli­ca­tions.

www.demm.co.nz/reader-en­quiry #150707.

Newspapers in English

Newspapers from New Zealand

© PressReader. All rights reserved.