#3 PROJECT Garden bench
Make the seat frame by attaching two 450mm lengths (22 x 69mm planed pine) between the ends of the 1 000mm lengths with screws. Do exactly the same for the backrest frame using the 22 x 44mm lengths. Place the seat frame and the backrest frame on the two 1 000 x 500mm laminated pine sheets and drill pilot holes. Screw the frames to the seat and backrest respectively.
Measure 600mm from one end of your work surface and draw a pencil line at right angles to the edge of the work surface. Measure and mark 450mm from the edge of the pencil line and draw a line at right angles to the end of the work surface. Place the 22 x 95 x 700mm piece (front leg) on the first pencil line and place the 22 x 95 x 725mm piece (back leg) diagonally from the corner of the work surface on the second line. Screw the seat frame below the 450mm mark to the legs. Make sure the short sides of the frame are flush with the front and back of the respective legs. Repeat on the other side of the seat frame.