This little box over a multi-plug creates a neat recharging station for the family’s cell phones and tablets.
You will need
• 22mm x 95mm pine cut into two 175mm pieces, one 300mm piece and one 256mm piece • 22mm x 144mm pine cut into two 300mm pieces • Alcolin Cold Glue Wood Glue • drill and 20mm spade bit • screws
2 2 Drill 20mm holes for the chargers’ wires. Fill all the screw holes with Alcolin Wood Filler, allow to dry, sand smooth and finish to your liking.
1 1 Make a bottomless box by gluing together the two 175mm pieces at right angles between the ends of one 22mm x 144mm x 300mm piece and the 22mm x 95mm x 300mm piece with Alcolin Cold Glue Wood Glue; screw together. Place the 22mm x 95mm x 256mm partition between them, 144mm from the back, and glue and screw together. Place the remaining 22mm x 144mm x 300mm piece on top; glue and screw together.