Keep your bath spoils close at hand with this neat caddy.
You will need
• 22mm x 95mm planed pine, cut to: five 740mm lengths two 220mm lengths • 6mm x 40mm chipboard
screws • Alcolin Ultra Wood Glue • Alcolin Woodfiller • 120-grit sandpaper
1 Using Alcolin Ultra Wood Glue and screws, attach the two 220mm pieces at right angles to three of the 740mm pieces, leaving a 6mm gap between the long pieces. Position the short planks so they fit snugly inside the rim of your bath. 2 Position the remaining 740mm planks vertically against the side of the base, flush with the bottom edge of the 220mm planks. Mark then saw off the four corners so the shelf rests on the edge of the bath. Glue and screw these planks to the base. 3 Fill the holes with Alcolin Woodfiller, allow to dry completely and sand to a smooth finish. Paint or varnish the wood in the colour of your choice.