FIT THE KIT
Tech Tip Don’t force the ring. It should slide easily into place.
Fit ring 1
Remove the rotor arm and fit the ring to the top of the distributor shaft. It should only fit one way round. If it’s tight, dress the inside with abrasive paper or deburr the edge with a sharp knife.
2 Fit trigger unit
Heat-sink paste is supplied with the kit. Put a few blobs of it under the trigger unit. Screw the unit on in place of the points. Aim for an even gap of 0.1-0.4mm between the trigger unit and the ring.
Secure wiring 3
Fit the rotor arm. Run the wires loosely round the distributor and use a cable tie to fix them neatly out of the way. Allow a little slack to accommodate the movement of the vacuum advance mechanism.