Fab­ric Bracelets

Woman's Weekly (UK) - - News -

You will need:

Fab­ric scraps Iron-on in­ter­fac­ing Clamp clasp Cut two pieces of in­ter­fac­ing, the di­am­e­ter of your wrist by width of your crimp clasp, then iron these to the re­verse of fab­rics. Cut out, adding 5mm seam al­lowance. With right sides to­gether, pin and stitch along edge of one long side of the in­ter­fac­ing. Press seam open, then iron seam al­lowances of un­stitched edges to the re­verse

along the in­ter­fac­ing edge. Fold bracelet in half along the stitched seam (right sides out) with ironed edges match­ing, then stitch through all lay­ers near out­side fold. Re­peat line of stitch­ing on the other edge to match. Use pli­ers to en­case ends into the crimp.

Newspapers in English

Newspapers from UK

© PressReader. All rights reserved.