MARK AND DRILL

Boating - - BOAT DOCTOR -

Make sure the top of the mount­ing flange is square with the up­per edge of the tran­som. Us­ing the flange as a tem­plate, mark the four out­side hole lo­ca­tions. Be sure you have ac­cess to the back­side of the tran­som for through-bolt­ing. If not, choose one of the al­ter­nate bolt holes in the bracket (there are three holes in each quad­rant). Check for in­ter­fer­ence from hoses and wires on the in­side of the tran­som be­fore drilling. Drill the four 3/8-inch holes, each at a right an­gle to the tran­som.

Newspapers in English

Newspapers from USA

© PressReader. All rights reserved.