Automate your power distribution with Elmeasure’s Intelligent ACCL
Frequent power failure in a day is exhausting due to repeated manual switching of the DG Set. This over usage causes wear and tear and leads to switch failure in the expensive equipment.
Elmeasure’s Intelligent Automatic source Change over with Current Limiter (iACCL) gives freedom from such maintenance problems. Built with high precision microcontroller that offers automatic changeover between main supply and generator supply, iACCL replaces dedicated manpower and also grants protection against overload/over voltage from the DG Set.
iACCL allows supply from mains as long as the load current is below the programmed current. When the mains supply fails and stand by generator supply is on, it connects the DG power to each consumer in sequence & starts monitoring its load.
Whenever the load current exceeds the allotment, power is automatically switched off for 10 seconds, and automatically restored. This cycle repeats for 5 times each time with double the time (20, 40, 80 & 160) and then enters into lockout mode until it is ‘Reset’ manually. This helps to protect against over voltage from DG.
Its current limiting capabilities are ideally suited to the efficient utilization of the standby generators frequently used in multi-storied apartments, commercial complexes, etc.
> Microcontroller based automatic source changeover with neutral isolation.
> DIN Rail/surface mountable for single phase and Surface mountable for 3 phase.
> SMPS based design for low power consumption.
> Intelligent re-connection once trip has occurred due to
either over voltage or over load.
> Manual Reset provision when in sleep mode for restoring
> Energy, Current, Voltage measurement for DG & Current
measurement for EB.
> Programmable threshold setting for both sources inde
> Over voltage protection for DG.