How to make

1

Remove the mirror and dismantle supporting struts, as/if required.

2

Identify the ‘brooding room’ by removing drawers to create a large, open space. Remove any supporting drawer runners or dividers to create a clean cavity. Keep any framework that may act as a ‘lip’ to help with the closing of the newly-created doors.

Julie’s tip

If no lip exists on the furniture, use strips of 10mm x 10mm wood pinned to the inside base and ceiling, inset approximately 25mm.

3

Sand all surfaces that need painting, including the faces of any drawers you are keeping, legs, and any internal rough areas that have been exposed by removing the internal drawer runners.

4

Paint prepared and exposed wood with undercoat/primer. Finish with 2-3 top coats of your choice. We re-used paint left over from our kitchen renovation: low sheen Resene Alabaster for the interior brooding space, Resene Quarter Tea for the exterior, and Resene Half Tea for the drawer faces and legs.

5

We used 38mm x 19mm dressed pine for the doors. Measure the cavity and cut vertical and horizontal door pieces to suit the space, allowing a 3-4mm gap all round for an easy fit. Join each corner of each door with a 38mm angle bracket, on the inside face, a total of eight brackets for two doors. Use a set square to help ensure they remain square.

Julie’s tip

Once assembled, place the door in position to check for a correct fit. If it’s slightly too tight or not perfectly square, now is the opportunity to plane any sides that stick.

6

Stain or paint the wooden door frames.

Use a set square while you screw the brackets in place to ensure they remain at a 90° angle.

7

When the stain or paint is dry, screw 1 x 50mm corner brace to each of the eight inside door corners.

Julie’s tip

Holding the frame upright in a bench vice makes this an easier, more accurate job.

8

Measure and cut the mesh to size, ensuring none of the mesh protrudes wider than the door frame. Place the doors on a flat surface with the bracket angles facing up. Attach the mesh to this side, which will be the inside of the door. Use 2.0mm x 15mm U-shaped staples, starting in each corner of the mesh, and complete with enough staples to ensure the mesh is secured. Use plenty of staples to keep the mesh securely in place.

9

Place the brooder on its back and lay the doors in place horizontally. Carefully fit the hinges, two for smaller doors three for larger doors, per door.

Mark and attach a slide bolt on each door, which should be sufficient to keep them secure. Attach handles or knobs to doors, if required.

Finished and ready for chicks. The width of this brooder means the heat source can be at one end, food and drink at the other.

10

Drill a hole in the back wall to allow a power cable to be threaded through. The height will vary, depending on whether you are using a lamp which needs to hang, or a heat pad or plate which sits on the floor.