Clamp­ing Washer Tool

Car Mechanics (UK) - - Cm Insider -

It’s al­ways tricky try­ing to re­move sprung steel clamp­ing wash­ers with­out break­ing or bend­ing the coarsely-threaded stud. This use­ful clamp­ing washer tool (part num­ber 7347) has been de­vel­oped to make re­moval a straight­for­ward task. De­signed for 32mm di­am­e­ter wash­ers, the two steel pins en­gage with the washer and al­low a cord­less drill or ¼in-drive wrench to spin the washer and wind its way off. This avoids break­ing the clip or dam­ag­ing the pin, as well as re­duc­ing the chance of the op­er­a­tor cut­ting them­selves on the sharp-edged clips if they shear. Ap­pli­ca­tions in­clude Audi, SEAT, Skoda and VW (OE washer num­bers, N90335004, N90335006, and N90796501) and Ford (OE 6715468), as well as many other makes. Com­pat­i­ble with clamp­ing wash­ers from Laser's Con­nect Workshop Con­sum­ables range (part num­bers 36149, 36150 & 36571).

The Laser clamp­ing washer tool has an RRP of £28.70.

Newspapers in English

Newspapers from UK

© PressReader. All rights reserved.