Demonstration
Step 5 1 Paint the black spots with the No. 00 brush and the same black and alizarin crimson mix from Step 3. Tidy up the right-hand side if you need to and reinforce any darks you see. Again, give the painting a dry.
2 If you are using white, mix it to a creamy consistency and paint the highlighted spots
you see in the photo. When you are about to reload your brush, make use of what little paint you have left on the bristles for the duller and finer areas, especially to the right-hand rim of the wing case.
2 Clean the brush and use it to lighten and soften edges of the white to give a blended effect. 3 Mix the following colours to a milky
Step 7 1 Time to paint the plant life! For the greens we will need milky consistency versions of: lemon yellow; olive green; sap green mixed with burnt umber; lamp black mixed with burnt umber; and the white paint we used earlier.
2 Work on one little area at a time, starting from the top down. Using the No. 1 brush, wet an area and fill this with lemon yellow. Whilst still wet, drop in the olive green, covering most of the lemon yellow. Add smaller amounts of the burnt umber and sap green mix, just to vary the colours. Do this for the rest of the plant. Give it a dry.
consistency: cerulean blue; phthalo blue; lamp black mixed with alizarin crimson
(50:50); and white for the highlights.
4 Wet the area just above the wing cases, which is called the pronotum. Drop cerulean blue over this area. Whilst wet, add phthalo blue to the middle of the area then the lamp black mix to the darker section. Give the painting a dry.
Step 6 1 Using the lamp black and alizarin crimson mix, lightly stipple the darkest areas of the pronotum. Look closely at the photo to see all these details. Space the dots out towards the lighter area then very lightly soften with a damp, clean No. 5 brush. Once dry, add a few white highlights.
2 Follow the same procedure for the head and paint the front leg. We need to leave the back legs until after we have painted the greenery.
3 For the antennae, lightly cover with milky yellow ochre, pop in a few burnt umber marks and add the tiniest amount of the dark mix we used earlier, just to define a few edges.
Step 8
1 Next, we need to define the blurry sections we can see in the photo and paint them a little sharper. Very lightly outline the inner edges of each section using a creamy sap green and burnt umber mix.
2 Fill these areas in one by one by adding the darker lines using the sap green and burnt umber and the burnt umber and lamp black mixes, varying the strength of these colours as you work through the sections. Think about shape, look at where some areas are lighter than others and, most of all, take your time.
Step 9 1 Give the painting a dry then use the lifting-off technique to add even more details, adding a few touches of watercolour white for those really bright areas.
2 When the white paint is dry, add a touch of yellow ochre over the top, but not over all the white areas. Do this in one go, otherwise you risk blurring the white paint.
3 Paint the remaining legs with the lamp black and alizarin crimson mix, adding a few white highlights tinted with a touch of the yellow ochre in places; this will give the legs a little bit of sparkle.