Today's Quilter : 2020-10-29

Darl Ing Dala L Project : 112 : 20

Darl Ing Dala L Project

darl ing dala l PROJECT 12 13 15 Mark a placement line at each end of a 2½in x 4¼in teal print piece with Template A ( Then, position and pin a prepared background piece with raw edge on the line ( – checking you have the right ‘side’ – and stitch ¼in from the edge. Flip ‘open’ and press ( Repeat on the other end ( Turn your block to the wrong side and trim using the base piece as a guide. Make twenty (20). To make the middle branch tier ( first prepare two (2) 2½in x 3in background pieces by placing them right sides together and trimming with a diagonal cut, as described in step 11. To make the top branch tier ( first prepare two (2) 3in background squares by placing them right sides together and trimming with a diagonal cut, as described in step 11. Mark a placement line at each end of a 2½in x 4¼in print piece with Template C. Join the side pieces to the print piece as before. Make twenty (20). Fig 4), Fig 5), Fig 3A). Fig 3B) 14 Mark a placement line at each end of a 2½in x 4¼in teal print piece with Template B. Join the background pieces to the print piece, as in step 12. Make twenty (20). Fig 3C). Fig 3D). 16 To assemble the small trees choose a mixed set of lower, middle and top branches and join, pressing as directed. Then add a section of trunk to the bottom and a 2½in x 4¼in background piece to the top ( Your block should measure 4¼in x 10½in. Make twenty (20) small pine trees. Fig 3A Fig 3B Fig 6). Fig 5 Piecing the large pine trees Fig 3C Fig 3D The large trees have four (4) tiers of branches. To keep the trees looking scrappy, divide the 2½in x 5¼in print pieces into four (4) piles, one (1) for each tier, and shuffle to randomly distribute the prints. The method to make the large tree is the same as for the small tree, but with different- sized pieces. Fig 4 Make 20 Fig 6 17 To make the lower branch tier, first prepare two (2) 2in x 3in background pieces by placing them right sides together and trimming with a diagonal cut, as described in step 11. Mark a placement line at each end of a 2½in x 5¼in print piece with Template A. Join the side background pieces to the print piece, as before. Make fourteen (14). 18 To make the lower middle branch tier, prepare two (2) 2½in x 3in background pieces following step 11. Mark the placement line at each end of a 2½in x 5¼in print piece with Template B. Join the side pieces to the print piece, again as described previously. Make fourteen (14). 19 To make the upper middle branch tier, prepare two (2) 3in background squares following step 11. Mark the placement line 20 Join us at www.gathered.how/todaysquil­ter

© PressReader. All rights reserved.