Plane lands on highway in NC
Craft clips two SUVs; no injuries reported
MONCURE, N.C. — A small plane experiencing engine problems struck two vehicles as it landed on a highway near a North Carolina airport, but no injuries were reported, authorities said.
The single-engine Lancair 360 with only the pilot on board landed near Raleigh Executive Jetport at Sanford-Lee County Airport in Sanford around 4:20 p.m. Thursday after experiencing engine problems, the Federal Aviation Administration said in a statement. The FAA will investigate.
The plane was traveling from Lynchburg to Ocean Isle Beach, North Carolina, according to FlightAware, which tracks flight activity.
The plane struck two SUVs as it landed on U.S. Route 1 — one sustained minor damage and no injuries were reported, Moncure Fire Department Chief Robert Shi said in a statement Friday.
The pilot said he experienced a prop failure that led to engine failure forcing an emergency landing, Shi said. The plane’s landing gear was not deployed, so it landed on its belly, he said.
“US1 is heavily travelled each afternoon and this incident could have been much worse,” Shi said.
The North Carolina State Highway Patrol said of the two vehicles clipped by the plane, only one driver filed a report, WRAL-TV reported.
Chris Sealey told WRAL-TV he saw a plane flying unusually low with no landing gear and thought that it was “a weird looking car” from a few miles down
the road.
“I mean, he was probably like 3 feet off the ground when I saw him, so I don’t think he had very long to go,” Sealey said.
“And, there was no big explosion or anything behind me, but you could tell like the traffic on both sides was kind of, you know, freaking out about it, but he had like a whole line of cars behind him.”