SEAT ASSEMBLY

06

With the cab floor cleared to make room for the new TMI bench, the guys began the assembly process first, starting with sizing up the new frame.

07

To allow the bench to be adjusted while on the track, TMI includes a pair of sliders in the kit.

08

To install the sliders, the seat was turned upside down, and each piece was fastened to either side of the bench.

09

An included wire rod was fed through a designated hole on each side of the sliders. This will allow the seat to slide forward and back evenly at both ends.

10

Next, the frame was attached to the bottom of the seat, ready to be installed inside the cab. Although the seat was fully assembled, there was still much more to do to the Ford’s interior before inviting it in. For the time being, it sat on the sidelines and watched as the rest of the steps played out.