I LIKE BIG BUTTS

> CHAD TALKS US THROUGH THE BASICS OF BUTT WELDING WITH BOTH MIG AND TIG WELDERS

MIG (Metal Inert Gas) and TIG (Tungsten Inert Gas) are the two most common types of welding practised in automotive applications. This month’s column will serve as an introduction to both types, for anyone wanting to jump in and have a crack themselves, using the most common of auto body metals: 1mm mild sheet steel.

PERSONAL PROTECTIVE EQUIPMENT

A GOOD helmet is right up there on the list of priorities, and like most things, you get what you pay for. This is one piece not to skimp on, as anyone who has suffered from welder’s flash will attest – you only get one set of eyes. A separate helmet for TIG and MIG is also handy, as MIG tends to dirty up lenses.

Fitted welding gloves, long sleeves, pants and enclosed boots are handy for avoiding MIG spatter.

Wearing fitted gloves and long sleeves will also help you avoid being burnt when TIG welding, but the real beauty of TIG is the lack of spatter, meaning you can wear shorts and thongs like a true-blue Aussie.

GAS

FOR MIG, use Migshield run at around 25-30. As mentioned above, it’s best to avoid gasless set-ups. Gas is used to shield the weld from oxygen and other crap in the atmosphere for both MIG and TIG.

For TIG, straight argon run at around 10 is sufficient for mild steel. Setting up post-flow for the gas will help protect the tungsten while cooling, and larger cups can be used for greater gas coverage.

USING A MIG

THE two pieces are pushed together, but a 1mm gap is left in the middle. This allows for when the two pieces are pulled together from the heat, known as weld creep. This gap also gives the MIG wire an area to melt, connecting the two pieces of metal together.

This join is formed from numerous tack welds made along the panel. A good weld here requires heat – enough to penetrate but not enough to blow a hole – and enough wire to not melt into the tip but not so much that it’s pushing the handpiece away before it burns. A good tack will have a small dimple on top.

After every few tacks, the area is cooled with compressed air. This is best done not too close to the panel, as a high-pressure blast on a hot weld will cause it to become porous.

Welding tacks onto 1mm sheet and trying to keep things cool is never going to look overly nice, but fear not, as these will be ground off anyway. Flipping the piece over, the penetration is okay, but lacking.

WORK ABILTY

AFTER a quick run though the English wheel, you can see the MIG weld is harder than the surrounding material and already starting to show signs of cracking, while the TIG weld will last all day.

THE most common type of join in this application is a butt weld; two pieces are simply pushed together to join with weld. While that’s pretty straightforward, the two types of welding machines can be used differently to achieve the same result.

These MIG welds will need grinding down, sometimes exposing areas that didn’t receive enough penetration. This and any impurities will end up leaving pinholes that require a few more tack welds and more grinding. At this point things are no longer overly workable. MIG welding will leave sheet metal hardened, and any hammer work can lead to the welded area cracking. This is not ideal for metal finishing. In TIG welding, the parent metals are simply (in this instance) fused together, leaving it malleable. The weld is not hardened and can easily be sanded down to clean up. This also means it is ideal for working into shape to get the best finish.