NBN setup guide
CONFUSED ABOUT WHAT’S INVOLVED WITH GETTING THE NBN HOOKED UP? WE OUTLINE ALL THE ESSENTIAL INFO YOU NEED TO KNOW.
SO YOU’VE CHECKED the rollout map at
nbnco.com.au and now know when you’ll be getting the NBN. And now you’d like to know how this whole thing works, what you’ll need and what you’ll have to do to set it up.
e answer to that really depends on what avour of NBN you’ll be getting. ere are six possibilities, and unfortunately, the rollout map doesn’t presently break it down by type other than xed line vs wireless.
You can make a guess: most of the areas currently covered by the rollout map are bre to the premises/home (FTTP) since that’s mostly the tail end of the original Labor NBN plan. If you can currently get Foxtel or Optus cable TV in your area, you’ll probably be getting hybrid bre coax (HFC). If you can currently get ADSL 2+ (but not cable or bre), you’ll probably end up on bre to the node (FTTN) or bre to the building (FTTB) in the case of unit blocks. And if you’re currently wireless, you’ll likely end up on either xed wireless or satellite. Of course, these are guesses — we wouldn’t recommend going out and buying equipment pre-emptively based on these assumptions!
So how will the rollout work for each of these? We’ll give you a quick breakdown.
FIBRE TO THE PREMISES
With FTTP, most of the equipment needed is built into the box that gets attached to your house during installation. All you will need is a generic broadband router with a gigabit Ethernet WAN port (many current DSL routers also have a gigabit Ethernet WAN port and can indeed be used with FTTP).
e installer will attach a utility box to the outside of your house as well as a connection box and power unit inside your home. e connection box has a gigabit Ethernet port on it (called UNI-D). It’s into this that you plug an Ethernet cable and connect it to the WAN port on your broadband router. e broadband router just uses DHCP for con guration, which is the default setting on most such routers.
FIBRE TO THE NODE/FIBRE TO THE BUILDING
FTTN and FTTB look and work a lot like ADSL. No new equipment is installed in your home and nobody needs to visit your premises. Your current phone line will remain your link to the internet.
ere will need to be one change on your end. Your old ADSL router won’t cut it anymore. You’ll need a modem router with support for VDSL2, the updated DSL standard being used for FTTN. Many newer ADSL routers also support VDSL, but older routers do not.
HYBRID FIBRE COAX
If you currently have HFC connected to your home, there won’t need to be any changes or anybody coming into your house. If you’ve never had cable TV or cable internet, however, an installer will need to come in and set it up. Typically, a wall plate will be set up into which a coaxial cable can be plugged.
If you don’t currently have a cable modem router, you will need one, which you’ll be able to purchase from your ISP. You can’t use a generic broadband router. ere are plans to upgrade the cable network in 2017/2018, which might again require a new router.
FIXED WIRELESS AND SATELLITE
Much like FTTP, an installer will need to come to your house and install equipment, which will include a connection box and a satellite dish or xed outdoor antenna. You connect to that equipment with a general broadband router (as with FTTP).