CRAFT PROJECT
Macramé wall hanging.
THIS LITTLE WILMA WALL HANGING
is 22cm wide and 75cm long. The pattern is very easy to make and mould according to your preferences. Add more cords to make it wider, or add more beads – this is a style to play around with.
YOU WILL NEED
56m twined 2.5mm cotton rope 40cm wooden stick or dowel 7 wooden beads, 2cm diameter
PREPARATION
Cut the following: • 18 cords, each 2.8m long • 1 cord, 3.9m long (extra-long to use as filler cord for the horizontal clove hitches; see opposite). Fold each of the 18 cords in half and attach to the dowel using a reverse lark’s head knot (see below). Fold the 3.9m cord with 1.4m on the left side and 2.5m on the right, then attach it to the right of the other cords using a reverse lark’s head knot.
KNOTS
REVERSE LARK’S HEAD The reverse lark’s head knot, commonly used to attach cords to dowel or an anchor cord, is worked in the same way as a standard lark’s head knot, but from the reverse so the bump is hidden. 1 Fold the cord in half. 2 Fold the loop towards you over the dowel or anchor cord.
3 Pass the 2 cord ends through the loop at the back and pull the cords to tighten the knot.
The horizontal clove hitch forms a straight line across a panel, with the filler cord running through it going either left to right or right to left, or bending back and forth.
1 To make a line going left to right, use the furthest left cord as the filler cord, holding it horizontally in front of all the other cords on the panel. Use the next cord to the right as the working cord for the first clove hitch, first bringing it forward, up and around the filler cord towards the left. Pull the working cord to tighten the loop while tilting the filler cord slightly upwards.
2 Finish the first clove hitch by taking the working cord around the filler cord again to the right of the first wrap, passing the end though the loop formed under the filler cord. Pull the working cord to tighten the knot. Repeat steps 1 and 2 for each cord to the right in turn.
3 To make another line underneath the first, bend the filler cord in front of the other cords on the panel horizontally from right to left. Repeat steps 1 and 2, but beginning with the right-hand cord and working each knot in reverse towards the left.
METHOD
1 Tie the first row of 37 horizontal clove hitches from right to left, using the 3.9m cord as filler cord. Place the knots just underneath the stick or dowel.
2 To make the second row, place the filler cord across the body of the work in the position you’d like the clove hitches to be and tie another row of horizontal clove hitches from left to right. When you reach the 26th cord (12th from the right), slide the first bead onto it, then make a horizontal clove hitch beneath it. Carry on to finish the second row.
3 For the third, fifth and seventh rows, the bead is placed on the 12th cord from the left (not counting the filler cord). On the fourth and sixth rows, the bead is again placed on the 26th cord from the left (not counting the filler cord).
4 For the last row, the bead is placed on the 19th cord from the left (not counting the filler cord).
5 Cut the ends to the same length. @createaholic