PLANTS

● Fresh flowers and foliage in various sizes (Rachel used large and small roses, anemone, stock, carnation, wax flower, ornithogalum and fern)

2Cut your flower stems to leave a few centimetres below each head and remove any leaves from the stem area. Cut individual wires for every flower or bunch at roughly five inches long. Tightly bind each wire against the stems with tape, starting from the head end and spinning stems to move downwards until you’ve covered the entire length of overhanging wire.

4Cut two lengths of ribbon, thread them through the loops at either end and use these to tie your finished creation in place around your head.

Your crown is complete!