HP PageWide Pro 477dw
Want an MFP for office work? The PageWide Pro 477dw is bulky but nothing short of brilliant
HP’s PageWide Pro 477dw is by far the most expensive inkjet in this group, but it’s unlike any other. The clue’s in the name: while the print heads in a normal inkjet whizz back and forth across the paper, which has to wait for them to cross, in HP’s PageWide system there’s a single set of heads spanning the full width of the page. Freed from the need to wait for moving print heads, the paper can get a shift on. For the 477dw, HP quotes a maximum speed of 55 pages per minute – the realm of high-end workgroup laser printers – although at the default quality it’s a more modest 40ppm.
The PageWide Pro 477dw isn’t really out to get small office inkjets; it’s positioned as a genuine rival to laser devices. Considering this, HP has wisely avoided small ink cartridges in favour of genuinely heavy duty supplies: the 477dw arrives with about 3,000 pages worth of black ink and 1,500 of colour, and replacement supplies are rated at 10,000 black pages and 7,000 for each of cyan, magenta and yellow. That cuts down on maintenance and waste, but it also means low running costs: each page of text and graphics will cost about 4.7p, while mono pages are less than 1p.
Several years after the debut of PageWide technology, there’s still a sense of surprise that an inkjet can print this quickly. Send a print job, wait for the dust cover to motor open, then watch as pages cascade into the output tray. The 477dw was comfortably the quickest colour printer in this test, dispatching 25 pages of black text at 34.9ppm, and extending this to 44.8ppm over a 100-page job when we dropped the quality to the “General Office” setting. It delivered our complex colour graphics test at 21.2ppm, and reached 12.2 images per minute (ipm) on our graphics duplex test. Kyocera’s Ecosys M2640idw was about 25% faster on the latter two, but it’s a mono laser that costs significantly more.
We aren’t keen on HP’s overly prescriptive TWAIN scan interface, but it’s hard to fault the 477dw’s scan performance. Tested over wired Ethernet it delivered A4 scans at either 150dpi or 300dpi in eight seconds. A 600dpi 6 x 4in photo scan was equally as fast, and at 1,200dpi the capture completed in 27 seconds. Perhaps not surprisingly, photocopies were also brisk, with a single page needing just 11 seconds. A ten-page ADF copy took 34 seconds in black, or 44 seconds in colour. With the ADF handling duplex scans in a single pass, double-sided copying is also very quick.
As with any inkjet, there’s a trade-off between speed and quality, but even at the fastest setting prints were far better than a typical inkjet’s draft mode. The default “Professional” setting produced strong black text and punchy colour graphics free from banding, grain or other inkjet artefacts. Photos were roughly as good as we’d expect from a colour laser, although the colour balance of both photo and graphical prints proved sensitive to paper quality, with the best results coming on thicker, whiter stock. Both also missed the waxy sheen typical of a good colour laser print.
With the same caveats, photocopies were excellent, with unusually strong colour and shade reproduction. Scans were also more than good enough for office purposes, although high-resolution photo scans appeared to have been sharpened, making them look a little artificial at 100% zoom.
Broadly, the 477dw matches the quality of a colour laser, but it’s much faster and quieter than any laser in the same price range, and costs less than half as much to run. It has some other key advantages: with no fuser to heat, its power consumption is far lower – we measured a peak of 58W, compared to 1,079W for the Xerox WorkCentre 6515 reviewed on p85. Finally, it’s quicker to get going: from standby, the 477dw spat out a first page in just seven seconds, although after an hour sitting idle this did rise to a more laser-like 17 seconds.
It’s hard to argue against the PageWide 477dw for a busy small office. Yes, it’s sensitive to paper quality, but any extra cost there is more than offset by savings on ink. Otherwise it’s fast, comparatively stylish, and produces great results. We can’t see a compelling reason not to choose it over a laser.