The imperfect vessel

Flying Cloud is a strong and capable little yacht. Her decks had been sheathed in epoxy, and she had a relatively modern aluminium rig and single cylinder Yanmar engine. But there were still three very important additions I needed to make before heading across the Atlantic: self-steering; a sprayhood; and drainage in the cockpit.

I had always believed modern sprayhoods looked tacky on classic yachts and for a long time I rejected the idea of getting one. But every time solid water cascaded over the cabin top, which happened quite a lot, a hose-like stream shot down from under the sliding hatch and soaked the inside of the cabin. Keith Buchanan from Rat Island Sailboat Company, based on the Isles of Scilly, put together a canvas sprayhood, which fitted nicely over my sliding hatch.

I also covered the cockpit footwell with plywood and made two drain holes through the transom. It wasn’t totally self-draining, but it was a lot better than before.

Lastly, my stepfather, Dave Cockwell, who happens to be a master shipwright, and I created a series of drawings for a bespoke self-steering system. It was loosely based the design by Blondie Hasler, the man who founded the OSTAR in 1960, where the wind vane turns the trim tab, and the flow of water past the tab causes it to swing in the opposite direction, altering the course of the yacht.

Apart from the wooden vane and nylon bearings, everything was made from stainless steel. There were no wires or lines and no possibility of wear.