Install a Pot Filler Faucet

A pot-filler faucet is useful when the sink and range are not in proximity, or if the cook finds it hard to carry heavy pots. The best time to install one is during major renovation, when plumbing can be roughed-in behind walls.

STEP 1

The pot filler should be at least 1” higher than the combined height of the stovetop and your tallest pot. Measure; and check faucet instructions. Consider how far the faucet swings and leave enough room for it to fold in toward the wall. A hole smaller than the dimensions of the faucet escutcheon will need to be cut through the plaster, drywall, or tile near the stove.

STEP 2

The pot filler will connect to the closest water line. Your plumber (or you, if you’re experienced and it’s legal) will turn off water at that line, then cut the line and solder on a tee. Next, run a copper pipe branch line to the faucet location. Apply flux outside and inside of each joint and solder all fittings. Depending on faucet model, the line may terminate with a threaded brass elbow (and nipple) or a slip elbow (needs male adapter soldered to end) soldered on a copper pipe.

STEP 3

The retention ring temporarily slides onto the faucet so that it can be centered on the brass nipple. With the retention ring in position, check that none of the screw holes runs over the water pipes. Mark the location of the holes with a pencil on the wall and remove faucet and ring. Drill pilot holes for the screws. Apply Teflon pipe sealant to the nipple or adapter. Slide on the rubber washer (if included) and attach the retention ring to the wall with screws.

STEP 4

Slide the escutcheon plate onto the faucet. Screw the faucet onto the nipple or adapter. Tighten the faucet with a rubber-strap wrench to prevent damage to fixture’s finish. Tighten the Allen screw at the bottom of the escutcheon. Check that the faucet is level. Unscrew the faucet’s aerator and clean out debris (e.g., copper shavings). Turn the water back on. Place a pot under the faucet and test it.